- News
- Reviews
- Bikes
- Accessories
- Accessories - misc
- Computer mounts
- Bags
- Bar ends
- Bike bags & cases
- Bottle cages
- Bottles
- Cameras
- Car racks
- Child seats
- Computers
- Glasses
- GPS units
- Helmets
- Lights - front
- Lights - rear
- Lights - sets
- Locks
- Mirrors
- Mudguards
- Racks
- Pumps & CO2 inflators
- Puncture kits
- Reflectives
- Smart watches
- Stands and racks
- Trailers
- Clothing
- Components
- Bar tape & grips
- Bottom brackets
- Brake & gear cables
- Brake & STI levers
- Brake pads & spares
- Brakes
- Cassettes & freewheels
- Chains
- Chainsets & chainrings
- Derailleurs - front
- Derailleurs - rear
- Forks
- Gear levers & shifters
- Groupsets
- Handlebars & extensions
- Headsets
- Hubs
- Inner tubes
- Pedals
- Quick releases & skewers
- Saddles
- Seatposts
- Stems
- Wheels
- Tyres
- Health, fitness and nutrition
- Tools and workshop
- Miscellaneous
- Buyers Guides
- Features
- Forum
- Recommends
- Podcast
Add new comment
4 comments
+1 to the above.
However, if you discover that your headset bearings are fine, the headset not done up over-tight, and you still have the problem, check that the steerer tube is completely straight (note: bends in steerer tubes are not always obvious just by looking at it - use a straight edge to check).
Bent steerer tube would be most likely as a result of a crash, or the bike being compressed front to back somehow. You didn't mention anything like this though
Yup, spot on, did a 100 miler today and by about 70 the headset was creaking and groaning big time , at least I think it was the headset, could have been me !
lift the bike off the ground and the steerer is fine, but put some weight through it and it's a very different story !
+1 on Mike the Bike's assessment. Knackered headset bearings.
I suspect you have a knackered steerer bearing. It's usually the lower and it ofter feels as though the steering is 'indexed' rather than turning freely.
Watch a YouTube video and have a go at regreasing it before you spend money on a new one.
Best of luck.