preferred-google-button
log in
register

Chain for ultegra 6800 set up

  • Creator
    Topic
  • February 10, 2015 at 10:44 am #23235
    allgearnoidea

    I’m not the most techy person but in the process of upgrading my bikes group set to ultegra 11 speed.

    I’m a bit stuck on what chain to get though there seems to be two ultegra 11 speed chains on the market and also kmc have been mentioned to me.

    Not sure if I need 114 or 116 links?

    I’ve got the larger rear mech ( and 32 cassette) and a 34/50 crank – any advice on what chain to use with this set up?

  • Creator
    Topic
Viewing 5 replies - 1 through 5 (of 5 total)
  • Author
    Replies
  • February 11, 2015 at 7:18 pm #831733
    0
    allgearnoidea

    yeah i am changing to a
    yeah i am changing to a larger 32 cassette – thanks for the advice

    February 11, 2015 at 12:07 pm #831731
    0
    2 Wheeled Idiot

    DanTe wrote: Just measure it

    DanTe wrote:
    Just measure it out against your old one.

    You can just measure against the old chain if cassette and chainring size are staying the same but if you’re changing (which it sounds like you are) you need to use an actual method to size the chain.

    February 11, 2015 at 9:22 am #831729
    0
    DanTe

    There’s some good deals on
    There’s some good deals on Ultegra and Dura Ace chains, 114’ll give you plenty enough links. Just measure it out against your old one.
    Always use a quick link, so much better and safer if you’re someone who continually takes his chain off to clean it. KMC 11 speed links work fine in shimano chains..

    February 10, 2015 at 9:59 pm #831727
    0
    allgearnoidea

    Thanks for that – good bit of
    Thanks for that – good bit of info

    February 10, 2015 at 10:56 am #831725
    0
    2 Wheeled Idiot

    All 11 speed chains (except
    All 11 speed chains (except maybe campagnolo) will work with your setup. KMC are widely used by many and are easier to set up due to the split link whereas with ultegra you need to fiddle around with a joining pin.

    The length of chain you will need will depend on several factors, cassette and chainring size but also chain stay length. This should be useful… http://www.parktool.com/blog/repair-help/chain-length-sizing (I use the big/big method and it works for me)
    You will probably need to shorten the chain in the end so either 114 or 116 links should work
    Hope this helps 🙂

  • Author
    Replies
Viewing 5 replies - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.