Component manufacturer SRAM has issued an immediate voluntary recall of their 10 speed PowerLock chain connector but they are emphatic that this is NOT a recall of their 10-speed chains ONLY the PowerLock connector link, PowerLinks on 8 and 9 speed chains are also unaffected.
One particular batch of the links is affected which the company says may develop a crack during installation or initial use which could cause the link and then chain to fail resulting in potential accident or injury. The affected batch are those with a date stamp (located on the outer face of the plates) with a code ending in either M or N. The batch in question may have been fitted as original equipment to chains or have been sold as an aftermarket replacement.
Only the PowerLock 10 speed connector links are affected, no other PowerLock links are part of the recall, nor are any SRAM chains or non PowerLock
SRAM’s voluntary recall notice advises consumers to stop using this product immediately. "Failure of the SRAM 10 speed chain PowerLock connector link, while in use, may result in loss of bicycle control and possible injury." and advises consumers to take their bike to their local SRAM dealer to have the link code verified to see whether it is one of the batch affected (see the diagram above for checking where the relevant code stamp on a PowerLock connector). According to the company the likely failure rate for the faulty batch is "2.5 connector plates out of 1000"
If you do have one of the connectors affected by the recall on your chain SRAM will give you a free replacement.

10 thoughts on “SRAM recalls 10-speed PowerLock chain connector links”
Is this what Cancallara broke
Is this what Cancallara broke on the Koppenberg?
Good point, I’ll ask…
Good point, I’ll ask…
Nope, just spoken to SRAM and
Nope, just spoken to SRAM and they tell me Cancellara’s problem on the Koppenberg wasn’t caused by a faulty PowerLock.
“In Cancellara’s case it was not a PowerLock failure, the chain unfortunately failed in very hard racing conditions.” says the man from SRAM Europe.
I wonder how you are supposed
I wonder how you are supposed to get it off?
They are one use only, and can’t see how you could take it off without having to remove the links of chain either side…
I think the idea is you take
I think the idea is you take your bike in to your local SRAM dealer, they verify whether you have one of the potentially faulty links, and if you do they change it.
But that must mean a
But that must mean a replacement chain surely?
You aren’t supposed to link the chains using a chain tool any more, so would either mean a new section of chain held in by 2 of the replacement links, or a new chain and single link.
You can use a chain tool to
You can use a chain tool to get the link off and put a new one on… well a SRAM dealer can anyway. Here’s the bit on the recall info for dealers dealing with just that. Dunno if I should preface this with “don’t try this at home” 😕
Oh, okay. I didn’t know you
Oh, okay. I didn’t know you could drive the pins out of the connector, I always assumed they were permanently attached.
Ah, I’ve just ordered a pair
Ah, I’ve just ordered a pair of these from CRC. Hopefully they won’t have sent me duff set. 😕
Wardy74 wrote:Ah, I’ve just
I doubt it …..this was 4 yrs ago……. :/