preferred-google-button
log in
register

Replace Cassette with an 11-42

  • Creator
    Topic
  • February 5, 2021 at 8:56 pm #31424
    Spif

    Hi everybody.

    So, I’d like to replace my 11-28 cassette on my CX with a larger one. Can I go to 11-42? (bike has Ultegra back and front derailleur and Rotor 3DF, 36/46 crankset). I’d obviously have to replace the cage… Can I do it?……

    Thanks.

  • Creator
    Topic
Viewing 8 replies - 1 through 8 (of 8 total)
  • Author
    Replies
  • February 6, 2021 at 6:29 pm #976153
    0
    travelsprint

    BCD is 110 (Giant TCX). I’ll

    BCD is 110 (Giant TCX). I’ll have to change deraileur cage, that’s expected. So basically 46-34 with 11-42 (or 12-42 if necessary) should do it?

    February 6, 2021 at 6:17 pm #976151
    0
    ChasP

    Exceeding the capacity of

    Exceeding the capacity of your rear mech isn’t the end of the world (unless you’re 1x). Provided your chain is long enough for big/big you just need to avoid small/small where it might go slack.

    February 6, 2021 at 5:12 pm #976149
    0
    Rich_cb

    AFAIK most front derailleurs
    AFAIK most front derailleurs can handle a 16t difference between big and little ring so that shouldn’t be a problem in isolation.

    If you change your chainrings and your rear cassette your rear derailleur capacity may be affected.

    I’m running mine 1x so not sure how big a cassette you could go to whilst simultaneously increasing the difference between your chainrings.

    February 6, 2021 at 5:10 pm #976147
    0
    Spangly Shiny

    Only if your BCD is 110mm. 

    Only if your BCD is 110mm. 

    February 6, 2021 at 4:34 pm #976145
    0
    travelsprint

    Thanks for the link…

    Thanks for the link…

    I was also planning to replace the 36 with a 34 in the Rotor 36/46 crankset. That would be ok, right?

    February 6, 2021 at 2:16 pm #976143
    0
    Rich_cb

    I have an RX 800 running 11
    I have an RX 800 running 11-40 with no issues.

    I do use a wolftooth derailleur hanger but I had it working ok without it (The 40t was a bit hit and miss).

    Road.cc did an article on this, was quite good.

    https://road.cc/content/feature/how-get-ultra-low-gearing-gravel-bike-adventures-246424

    February 6, 2021 at 1:41 pm #976141
    0
    Achtervolger

    I’ve read that the above part

    I’ve read that the above part can extend your cassette range, without needing to replace your existing derailleur. I’m not sure if it would enable 28t up to 42t though. Perhaps other contributers can clarify.

    February 6, 2021 at 1:36 pm #976139
    0
    Achtervolger

    https://www.merlincycles.com

    https://www.merlincycles.com/sunrace-rear-derailleur-extender-link-134836.html?utm_source=PHG&utm_medium=AffiliateMarketing&utm_campaign=phg-GB&ucpo=66524&source=PHG

  • Author
    Replies
Viewing 8 replies - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.