[witty.name]

[url=http://www.flickr.com/photos/steverog5/4207818411/][/url]
[url=http://www.flickr.com/photos/steverog5/4207818411/]P1000131[/url] by [url=http://www.flickr.com/people/steverog5/]steverog5[/url], on Flickr[url=http://www.flickr.com/photos/steverog5/4207818411/][/url]
[url=http://www.flickr.com/photos/steverog5/4207818411/]P1000131[/url] by [url=http://www.flickr.com/people/steverog5/]steverog5[/url], on Flickr

Columbus XCR stainless steel tubes with no braze on’s.18 months old,covered around 1000 miles.Built with phil wood hubs and titanium bottom bracket,mavic open pro,edge full carbon fork,chris king headset,paul components crankset,ultegra brake,kent eriksen ti seatpost(not shown in pics).No pedals.Weighs around 15lb without pedals.120mm rear spacing with slot dropouts fixed wheel only.Seatstay bridge sits close against a 23c tyre.Allround mint condition.

Just over £4000 to build,looking for £1750 to part fund new indy fab mountain bike.Thanks.

Topic

[witty.name]

Yes,sold.
Thanks.
Yes,sold.
Thanks.

[johnf]

Hi, did this sell ?
Hi, did this sell ?

[witty.name]

Yes,geometry would help
Yes,geometry would help wouldnt it.

Seat tube 56.5cm and 73.5 degrees
Top tube 56cm and horizontal at zero degrees
Head tube 178mm and 73 degrees.
Floor to centre of crank bolt 275mm
Standover 83cm
Wheelbase 99cm.

Im 6ft tall and on the build sheet was given a recommended stem of 110mm with minus 6 degrees and 20mm of headset spacers.Thanks.

[Gkam84]

Just had a look on your
Just had a look on your Flickr, you weren’t joking when you said it sits close to the tyre

[RichTheRoadie]

+1 on geometry…
+1 on geometry…

[ilovemytinbred]

Hi any info about size/geo
Hi any info about size/geo

[Author]

Replies