FELT AR 2015 fitting Rotor 3D+ (MAS) cranks issue

Royal1664 · 2015-09-11T13:57:28+01:00

Hi Team, Anyone got a felt AR with Rotor cranks if so what spacer did you use. Currently the only way I can fit them is to have an 11mm spacer on the non drive side and no spacers on the right.The bike is bb30 with a 68mm bb.

This topic has 2 replies, 2 voices, and was last updated 10 years, 10 months ago by Royal1664.

Creator

Topic
September 11, 2015 at 1:57 pm #24779

Royal1664

Hi Team,

Anyone got a felt AR with Rotor cranks if so what spacer did you use. Currently the only way I can fit them is to have an 11mm spacer on the non drive side and no spacers on the right.The bike is bb30 with a 68mm bb.
Creator

Topic

Viewing 2 replies - 1 through 2 (of 2 total)

Sort:

Author

Replies
September 12, 2015 at 3:13 pm #859355
0

Royal1664

James thanks for the post
James thanks for the post mate!

Found out that I had been sold one from a cervelo display bike so the cranks were factory make to only fit thoughs bikes!!! Bad times.

Cheers

Si

September 12, 2015 at 3:03 pm #859353
0

jimt

I have but can’t see what you
I have but can’t see what you are struggling with. (assuming you are using the 30mm axle ones)
I have an original AR2 and have fitted the Rotor power cranks. No spacers were required. 11MM is quite a lot as far as I understand there should be no Rotor cranks that require a spacer that big on a BB30.

On mine I have the bearing covers and did not require any of the very thin plastic washers. Do you have the rotary preload adjuster on the cranks?

Thanks
James
Author

Replies

Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.