preferred-google-button
log in
register

Disc rotor lockring question

  • Creator
    Topic
  • September 7, 2019 at 7:42 pm #30090
    L3gion

    Centrelock disc rotors, on hunt wheels, 12mm thu axles…

    When I tighten up the lockring on the rear rotor (to 40NM as I normally do) the wheel starts to drag a little, even when not fitted to the bike and just spinning the hub. As soon as I loosen off the locking it moves smoothly again.

    I’m confused – any thoughts please?

  • Creator
    Topic
Viewing 4 replies - 1 through 4 (of 4 total)
  • Author
    Replies
  • September 9, 2019 at 12:07 pm #949591
    0
    L3gion
    CXR94Di2 wrote:
    You need to check the lockring isnt pressing against the bearing face when tight. 

     

    It could be the lockring needs slightly filing down in thread length or a different make of lockring.  It might on need 1mm or less to stop the drag on wheel rotation- never experienced this myself.

    Thanks for the advice. I’ve had a discussion with Hunt now, and it looks like my wheel is accidentally missing a red washer thats some sort of spacer fitted between the freehub and the shell.

    It would make some sense that if this is missing, then the force generated by fitting the lockring might be putting a little bit of compresive force where it shouldn’t.

    The red washer is on its way, along with a replacement lockring (just in case). I’ll update this when I’ve sorted it…

    September 9, 2019 at 7:31 am #949589
    0
    CXR94Di2

    You need to check the

    You need to check the lockring isnt pressing against the bearing face when tight. 

     

    It could be the lockring needs slightly filing down in thread length or a different make of lockring.  It might on need 1mm or less to stop the drag on wheel rotation- never experienced this myself.

    September 8, 2019 at 11:09 am #949587
    0
    L3gion
    VonPinkhoffen wrote:
    Tighten the rotor, then adjust your caliper alignment by loosening the bolts and either use spacers on the rotor or (my favoured method) an elastic band on the brake lever to align the calipers to the rotor. 

    Unfortuantely as I said, it was doing it when not fitted to the bike. Although the rotors didn’t appear to be rubbing, I re-aligned them anyway using a birzman clam. So that wasn’t it.

    In the end I seem to have fixed it by swapping the rotor lockring for an identical one off my other set of wheels.

    No idea why that is…

    September 8, 2019 at 10:08 am #949585
    0
    VonPinkhoffen

    Tighten the rotor, then

    Tighten the rotor, then adjust your caliper alignment by loosening the bolts and either use spacers on the rotor or (my favoured method) an elastic band on the brake lever to align the calipers to the rotor. 

  • Author
    Replies
Viewing 4 replies - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.