log in
register

Repairing a Vitus bonded frame?

  • Creator
    Topic
  • June 26, 2009 at 12:42 pm #11804
    TRs Blurb n Blog

    I have an old Vitus 979 Dural bonded aluminium frame and the bond between the seat tube and the bottom bracket has come apart. Does anybody know if it can be repaired and who could do it?

  • Creator
    Topic
Viewing 3 replies - 1 through 3 (of 3 total)
  • Author
    Replies
  • June 26, 2009 at 3:10 pm #629883
    0
    TRs Blurb n Blog

    Yes, the alloy tubes are
    Yes, the alloy tubes are bonded with a dry heat epoxy to cast alloy lugs. It would be nice to get the main tubes replaced otherwise it will remain hung up to just look at because it is pretty but probably too dangerous to ride.

    June 26, 2009 at 3:01 pm #629881
    0
    Barry Fry-up

    No More Nails?

    seriously
    No More Nails?

    🙂

    seriously though, bike companies only say ‘bonded’ because no-one would buy a ‘glued’ frame, that’s all it is. the strength of the bond is in the preparation of the surfaces as much as anything. The stuff they use to glue it isn’t much more technical than araldite, so far as i’m aware. not that i’m advocating a DIY job 😕 😕

    June 26, 2009 at 2:21 pm #629879
    0
    Tony Farrelly

    When you say ‘bonded’ do you
    When you say ‘bonded’ do you mean lugged and glued? If you do that might be tricky and I’m not sure it would be that advisable either. I saw a bonded Vitus snap once – it was nearly very nasty indeed.

  • Author
    Replies
Viewing 3 replies - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.