Previous Forum topic
Next Forum topic
Sky Giro 2013 team
When I give it some full beans on the big ring the chain skips to the smaller front chain ring, anybody got any remedies?...
6 user comments
You might just need to readjust your front mech. It will also help if your chain isn't crossing too far over on your cassette. Make sure you're in a good gear to start with!
posted by YorkshireMike [92 posts] 24th April 2013 - 16:28
Ta, giving it a bit of thought I reckon it is when the chain is up the block a few gears. I just need to man up and leave it in the 53-11 all the time
posted by slowclimb [57 posts] 24th April 2013 - 16:44
Can happen with a worn chain or gear ring.
Measure your chain for wear?
posted by Cycleoptic [19 posts] 24th April 2013 - 16:54
Check your front mech Limit Screws, specifically the one marked 'H'. If the mech cage can't shift enough from the frame it might be pulling the chain back towards the inner ring (hope that makes sense).
To check, put the chain on the large chainring and smallest sprocket. Pull the inner cable for the front mech by hand and you should have a small gap between the chain and outer cage so there's no rubbing. If you don't, loosen the H screw a quarter of a turn at a time.
Then go out and continue to give it the beans.
posted by arrieredupeleton [586 posts] 24th April 2013 - 17:19
I had this problem, needed a new cable. I took mine in as I couldn't see the issue, was just a new inner needed
posted by pdows47 [110 posts] 24th April 2013 - 20:13
Thanks chaps, I'll check all those things
posted by slowclimb [57 posts] 24th April 2013 - 20:54
Events coming up