Before I start, NB I am referring to Campag Power Torque, not their Ultra Torque system.
Has anyone got experience of fully servicing a Campag power torque BB/chainset? I intend to get the Park CBP3 and CBP5 tools, and can see how to use them to remove the chainset and drive-side bearing. However, removing the non-drive side bearing from the cup seems a bit of a mystery! The only ref I have found so far is from the Park website:
"The left side bearing is pressed into the cup. It is Campagnolo's intention that this entire cup with bearing should be replaced when bearing is worn out."
If this is the case, it doesn't seem too helpful a design as I will need to buy more than just a pair of bearings...has anyone had experience of successfully replacing the bearing from the non-drive cup?